MANUFACTURE FROM MATERIALS OF ANY HEADING

Description
Nitrile gloves, disposable.

Mode of use
Wear the gloves on the clean and dry hands and without rings, bracelets, watches, piercings, etc., so that the glove is adherent to the fingertips and the palm without risk of superficial lacerations. To determine the correct size of the glove consider that it should not tighten the hand and even be too lasco.
Procedure for removing contaminated gloves
1. To start removing them, grab the palm of the undominant hand and pull out the glove.
2. Slide your hand out and hold the empty glove in the hand that still has the glove. Don't touch the glove with your bare hands.
3. Now slide the index finger of the naked hand at the bottom of the other wrist, inside the contaminated glove, paying attention not to touch outside it and pull the glove on what you have in your hand.
4. Disposal in the container.
5. Wash your hands, carefully, possibly with a disinfectant soap.

Warnings
This information does not reflect the effective duration of workplace protection and the differentiation between mixtures and chemicals as well.
Chemical resistance has been evaluated in laboratory conditions by samples taken from the palm alone and refers to chemicals tested. It can be different if the chemical is used in a mixture. It is recommended to verify that gloves are suitable for the intended use because the conditions at the workplace may differ from the test depending on temperature, abrasion and degradation.
When used protective gloves can provide less resistance to dangerous chemicals due to changes in physical properties and significantly reduce the actual usage time. For corrosive chemicals, degradation can be the most important factor to consider when choosing chemical resistant gloves.
Before use check that the glove is in good condition: that is, there are no cuts, holes, cracks etc. if these conditions are not respected, immediately replace the DPI/DM. The glove must be used only for the risks provided for in this information note and no alterations to the certified configuration are allowed. In case of use as a medical device in the field NOT EXTERNAL, the use must be temporary if used in an invasive way, in relation to the natural orifices of the body. It should not be used in contact with open wounds or in surgery or in non-natural orifices of the body or where the sterility of the device is required.
The information note must be kept for the duration of the DPI/DM in use.
The packaging, once opened, must be protected from direct exposure to sunlight and fluorescent light.
Gloves are packed in cardboard boxes.
Gloves must be kept in their original packaging, in a clean and dry place, sheltered from excessive heat sources (> 30°C) and direct sunlight. Please refer to the user the verification of the integrity of the glove before putting into use. The glove must be used, in full packaging and in storage conditions as indicated on the package, maximum within the expiry date indicated on the same.
Gloves must be replaced at the end of their use being “monoused” and therefore cannot be subjected to maintenance, washing and reuse.

Conservation
Keep away from light, in a cool and dry place.
Validity of whole packaging: 60 months.

Format
Pack containing 100 gloves, size L.

Cod. G00113