Descrizione Clinica
medifit
Description
Alcool tester.
Warnings
- The test detects the concentration of alcohol in the blood at the time of measurement. The level of alcohol in the blood can vary depending on the environmental conditions. This product must be used only as a tool for prevention and promotion of a more responsible and safe guide, provides a purely indicative measurement, does not exclude or replace any checks carried out by the competent authorities, which can give rise to values other than those obtained through the measurement with the test. Alcoholic rate values measured by the test are not relevant for legislative purposes, nor do they exempt the subject from any liability. Non-correct preservation of the product and/or incorrect use of the product, can affect the accuracy of measurement.
- Do not rely solely on this product to determine a possible state of drunkenness and therefore decide to drive a vehicle, use dangerous tools or take risky activities.
- INNOLIVING Spa is not responsible for the consequences of improper use of this product.
- Before use make sure that the appliance is intact without visible damage. In case of doubt do not use the product and contact the authorized service.
- After use, always store the product away from heat sources, sun rays, moisture, sharp or similar objects.
- Do not use alcoholic substances such as paints or insecticides near the tester.
- Don't use chemicals to clean the tester. Never immerse the product in water or other liquids, the sensor may damage.
- Do not attempt to repair the product yourself, unless the warranty is dropped, but always contact the authorized service.
- It takes about 20 minutes for alcohol to be absorbed into the bloodstream from the digestive system; therefore, it is recommended to carry out the measurement after 20 minutes from the consumption of alcoholic beverages. If the measurement is carried out immediately after drinking, the results can reflect the concentration of alcohol present in the drink and not the actual concentration in the blood.
- To achieve more accurate measurement results, the interval between two consecutive measurements must be more than 3 minutes.
Cod. MD-644
Alcool tester.
Warnings
- The test detects the concentration of alcohol in the blood at the time of measurement. The level of alcohol in the blood can vary depending on the environmental conditions. This product must be used only as a tool for prevention and promotion of a more responsible and safe guide, provides a purely indicative measurement, does not exclude or replace any checks carried out by the competent authorities, which can give rise to values other than those obtained through the measurement with the test. Alcoholic rate values measured by the test are not relevant for legislative purposes, nor do they exempt the subject from any liability. Non-correct preservation of the product and/or incorrect use of the product, can affect the accuracy of measurement.
- Do not rely solely on this product to determine a possible state of drunkenness and therefore decide to drive a vehicle, use dangerous tools or take risky activities.
- INNOLIVING Spa is not responsible for the consequences of improper use of this product.
- Before use make sure that the appliance is intact without visible damage. In case of doubt do not use the product and contact the authorized service.
- After use, always store the product away from heat sources, sun rays, moisture, sharp or similar objects.
- Do not use alcoholic substances such as paints or insecticides near the tester.
- Don't use chemicals to clean the tester. Never immerse the product in water or other liquids, the sensor may damage.
- Do not attempt to repair the product yourself, unless the warranty is dropped, but always contact the authorized service.
- It takes about 20 minutes for alcohol to be absorbed into the bloodstream from the digestive system; therefore, it is recommended to carry out the measurement after 20 minutes from the consumption of alcoholic beverages. If the measurement is carried out immediately after drinking, the results can reflect the concentration of alcohol present in the drink and not the actual concentration in the blood.
- To achieve more accurate measurement results, the interval between two consecutive measurements must be more than 3 minutes.
Cod. MD-644
