Descrizione Clinica
Complete set for aerosoltherapy
Description
Class IIa medical device.
The aerosoltherapy set is designed to treat respiratory diseases quickly and effectively.
It can be used with all compressed air aerosols.
Mode of use
Before using the aerosoltherapy set make sure to clean all parts of the device.
Open the nebulizer and pour the amount of medicine prescribed by your doctor; be careful not to exceed the notch of the maximum level. Connect the nebulizer to the compressor via the air pipe. Place the most suitable accessory for inhalation therapy: mask, mouthpiece or nasal dispenser. Sit in a relaxed position with the upper body straight. Make sure the air tube does not contain condensation; in this case turn on the compressor to dry the moisture present.
Finished the therapy clean all parts of the set.
Cleaning and disinfection
After each treatment, carefully clean all parts of the set to eliminate any drug residues.
The air pipe must be cleaned with a damp cloth.
Always wash your hands thoroughly before cleaning and disinfecting accessories.
Wash/sterilize each part of the nebulizer.
Replace the air tube when switching to a new patient or in case of impurities.
- Cleaning with water
Wash all parts of the appliance (except the air tube) under hot running water for about 5 minutes. Rinse thoroughly, taking care to remove all the residues, then let dry in the air.
- Disinfection
Chemical solutions can be used to disinfect all parts (except the air pipe), following the manufacturer's instructions. Disinfectants are generally available at pharmacies.
- Sterilization in boiling water
All properly separated components (except for air pipe and masks) can be boiled in plenty of water for no more than 1 minute.
Warnings
Strictly stick to the target of use of the device.
The device must be cleaned before use.
Use the device carefully.
The device does not contain latex and does not contain phthalates.
If the device is not subject to the cleaning procedures indicated before its use, infections and septicemia may occur.
Do not use the device if it has defects or anomalies.
Keep out of reach of children.
Do not place heavy items on your device. Do not expose your device to mechanical stress.
Before use, make sure that the device is intact and undamaged, that it has not changed color or axuma disogenous colorations, do not have surface molds, etc. If any of these cases occur, remove the device and replace it immediately.
During use, make sure the compressor works, that the air tube is properly connected to both ends and is not crushed, bent, dirty or obstructed. If necessary, replace it with a new one.
Make sure the nebulizer components are assembled correctly.
Make sure the medicine has been poured into the nebulizer.
Conservation
Store in a cool and dry place, away from heat sources and direct exposure to the sun.
Validity of whole packaging: 36 months.
Format
The package contains:
- 1 ampoule;
- 1 adult mask;
- 1 child mask;
- 1 small mouth;
- 1 nasal repeal;
- 1 pipe length 150 cm.
Cod. FOR.002.020
Class IIa medical device.
The aerosoltherapy set is designed to treat respiratory diseases quickly and effectively.
It can be used with all compressed air aerosols.
Mode of use
Before using the aerosoltherapy set make sure to clean all parts of the device.
Open the nebulizer and pour the amount of medicine prescribed by your doctor; be careful not to exceed the notch of the maximum level. Connect the nebulizer to the compressor via the air pipe. Place the most suitable accessory for inhalation therapy: mask, mouthpiece or nasal dispenser. Sit in a relaxed position with the upper body straight. Make sure the air tube does not contain condensation; in this case turn on the compressor to dry the moisture present.
Finished the therapy clean all parts of the set.
Cleaning and disinfection
After each treatment, carefully clean all parts of the set to eliminate any drug residues.
The air pipe must be cleaned with a damp cloth.
Always wash your hands thoroughly before cleaning and disinfecting accessories.
Wash/sterilize each part of the nebulizer.
Replace the air tube when switching to a new patient or in case of impurities.
- Cleaning with water
Wash all parts of the appliance (except the air tube) under hot running water for about 5 minutes. Rinse thoroughly, taking care to remove all the residues, then let dry in the air.
- Disinfection
Chemical solutions can be used to disinfect all parts (except the air pipe), following the manufacturer's instructions. Disinfectants are generally available at pharmacies.
- Sterilization in boiling water
All properly separated components (except for air pipe and masks) can be boiled in plenty of water for no more than 1 minute.
Warnings
Strictly stick to the target of use of the device.
The device must be cleaned before use.
Use the device carefully.
The device does not contain latex and does not contain phthalates.
If the device is not subject to the cleaning procedures indicated before its use, infections and septicemia may occur.
Do not use the device if it has defects or anomalies.
Keep out of reach of children.
Do not place heavy items on your device. Do not expose your device to mechanical stress.
Before use, make sure that the device is intact and undamaged, that it has not changed color or axuma disogenous colorations, do not have surface molds, etc. If any of these cases occur, remove the device and replace it immediately.
During use, make sure the compressor works, that the air tube is properly connected to both ends and is not crushed, bent, dirty or obstructed. If necessary, replace it with a new one.
Make sure the nebulizer components are assembled correctly.
Make sure the medicine has been poured into the nebulizer.
Conservation
Store in a cool and dry place, away from heat sources and direct exposure to the sun.
Validity of whole packaging: 36 months.
Format
The package contains:
- 1 ampoule;
- 1 adult mask;
- 1 child mask;
- 1 small mouth;
- 1 nasal repeal;
- 1 pipe length 150 cm.
Cod. FOR.002.020
